Lifting a ZTR to change blades

[outdoor]

Can you help me out?
I'm wondering what would be a safe and practical way to get a ZTR up, so that I can change the blades. I would appreciate any suggestion.

Thanks,
Outdoor

[Scott]

car ramps, hydraulic lift, your trailers ramp, etc...

If you use any type of ramp, make sure you chock the back tire(s)

[Phil Nilsson]

Check lifting options ... at this site ...

http://www.ballard-inc.com/products.htm

[MortNuke]

Phil, that's a great site for me...I need to look into "trailor organizing accessories" to mount my blower, trimmer and stick edger. Thanks.

[outdoor]

Thanks for the Ballard site

Phil,
The Ballard "Super Lift" looks like what I need. Quick, simple, and safe. The "Army of Guys", that are willing to share ideas on your Web-Site is just great.

Thanks Again,
Outdoor

[Maddog]

I use the car ramps when at the shop and the trailer ramp when out. These ways have worked well for me for over 4 years now.

[CleanEdge]

I use a hydraulic jack, and it works fine for me. Gets it a little higher off the ground then the trailer ramp

[Phil Nilsson]

You would think by now ... all heavy mowers would come with factory built-in lifting jacks.

Phil

[THE_CROOKED]

i know a guy who has a VOVLVO LOADER WITH CLAWS he could scoop it up for u and flip it over a few times LOLS joke...

i would say find a nice high curb and carefully back off it and put the brake on and reach down under it... thats how i do it